JCM TAIKO PUB-7/11, Руководство по эксплуатации и обслуживанию

Страница: 31 / 84

P/N 960-100175R_Rev. 4 {EDP #200824} © 2013, Japan CashMachine Co., Limited
2 - 7
Installation Taiko™ Series Banknote Acceptor Section 2
Operational Check
Once the Taiko™ Unit is installed, perform the

following steps to ensure the Taiko™ Unit is in its
normal Operational Mode:
1. Remove Power and perform Test No.5 “Accep-
tance Test Procedure” on page 6-9 of Section 6 in
this Service Manual.
2. Return the DIP Switches to their pre-Test Opera-
tional Mode positions, and re-apply Power to the
Taiko™ Unit.
Table 2-9 Taiko Sensor Type Cleaning Methods
Sym. Sensor Type Cleaning Method
a
Side Sensor
Wipe clean using a lint free cloth or blow clean using
Compressed Air.
*
b Validation Sensor
c Entrance Flapper Sensor
d Entrance Sensor
e Side Sensor Prism
f Upper Transport Sensor
g Entrance Sensor Prism
h Bend Lever Sensor
i Upper Transport Sensor Prism
j Lower Transport Sensor
k Lower Transport Sensor Prism
*. Wipe and clean all of the Rollers and Green Belts shown in Figure 2-21 using a soft lint-free Cloth.
Taiko Sensor and Roller Locations
Figure 2-21 illustrated the various Taiko Sensor cleaning locations, and Table 2-9 respectively lists the
Taiko Sensor Type Cleaning Methods.
Figure 2-21 Taiko Sensor Cleaning Locations
Dummy Head
b
c
d
g
d
e
b
f
e
j
h
a
a
i
Magnetic
Head Roller
k
g