Doc ref. :
332190D –
EN
28.04.2014
Page 30 / 49
5.9 Identity code
5.9.1 Identity code selection
The identity code is used to pair the handle and its receiver.
To communicate with a receiver RSRB, the handle must be programmed with the same identity code.
5.9.2 Reading the identity code, software version and SIM card serial number
•
Pick up the handle, leaving the trigger in the
released position.
•
Simultaneously press buttons B2 and B4
The identity code used, the software version
and the SIM card serial number are displayed on
the screen.
•
Press
EXIT
(B2) to exit.
The receiver identity code is given on the external label.
5.9.3 Changing the identity code
The identity code programmed in the handle is stored in the SIM card.
You can change the identity code using the Dialog RSP software (see Dialog RSP manual) or by replacing the SIM
card by a card corresponding to the receiver (see § « Setting backup handle into service », or contact your installer).
Note : The identity code programmed in the receiver cannot be changed
.
(1) released
(2) activated
(3) clenched
3-position trigger
(1) released
(2) activated
2-position trigger