Doc ref. :
332190D –
EN
28.04.2014
Page 25 / 49
5.5 Charger : wiring and management.
5.5.1 Association of charger and wireless enabling handle
If the charger has not been associated to its handle, refer to the section entitled « Setting the charger into service ».
5.5.2 Wiring of charger power supply
To supply the charger, refer to the section entitled « Setting the charger into service »
5.5.3 Taking the wireless enabling handle off its charger
When the wireless enabling handle is withdrawn from its charger, you have a limited time delay to activate the trigger.
After this time delay, safety relays K1 and K2 de-energise to stop the equipment.
This time delay is configurable between 5 and 30 seconds by 2 «A» selectors on the receiver.
The 2 selectors must always be set to the same position.
Position «A»
selectors
0
1
2
3
4
5
6
7
8
9
Handle pickup time
delay
5 s.
6 s.
7 s.
8 s.
9 s.
10 s.
15 s.
20 s.
25 s.
30 s.
Note :
The two «
A
» selectors are also used to define the machine area access time described in the previous section. If this area
access function is also used, the position of the two « A » selectors must be chosen to best satisfy the two functions
5.5.4 Setting the wireless enabling handle on its charger
When you go to set the wireless enabling handle on its charger, you must keep the trigger activated until the green
indicator light on the charger comes on (when you are within 30 cm of the charger). You can then release the trigger
without de-energising the safety relays, then set the wireless enabling handle on its charger.
The enabling handle recharges once it is engaged on its charger.
