Janome Horizon Memory Craft 15000, Инструкция по эксплуатации

Страница: 90 / 184

e
r
t
w
Button Sewing
When attaching a button to thick fabric, you need to
make a shank by using the button shank plate.
The feed dog lowers automatically when selecting the
button sewing section.
Attaching the button sewing foot T
Make sure to press the lockout key to lock the machine.
Insert the rear pin of the foot into the rear groove of the
foot holder.
q
Rear pin
w
Rear groove
Gently lower the presser foot lifter while holding the foot
with your finger to fit the foot. Press the unlock key to
unlock the machine.
Place a button on the fabric and lower the needle into the
left hole of the button by turning the handwheel with your
hand.
Insert the button shank plate under the button.
Lower the foot to hold the button in place, aligning the
direction of the button.
e
Button shank plate
Raise the needle by turning the handwheel until the
needle bar swings to the right.
Press the “+” or “–” key so the needle enters into the right
hole of the button. The maximum stitch width is 0.7 cm
(1/4˝).
Start sewing and continue until the machine stops
automatically.
Remove the fabric from the machine.
Cut the all threads leaving at least 10 cm (4˝) tails.
Trim the threads at the end close to the fabric.
Pass the needle thread at the beginning of stitching
through the left hole in the button, between the button
and fabric.
Pull the needle thread to bring the bobbin thread up to
the right side of the fabric.
r
Needle thread at the beginning
t
Bobbin thread
Wind the threads to form a shank and knot them together.
q
NOTE:
The button shank plate cannot be used if the button is
too thick.
85