Jadak PHOTO RESEARCH SpectraScan PR-655, Руководство пользователя

Страница: 133 / 160

PR-655/670 User Manual
117
Command Description
R
Purpose : Recall stored measurement data from the PR-6XX
Syntax : R<data code>,<Measurement #>,<filename.ext>[CR]
Response : 0000,<data>[CR][LF] If all OK, else
NNNN[CR][LF] (NNNN = Error code)
Special Syntax 1 (Recall from RAM only):
Syntax : R<data code>,0[CR] Recall last written measurement
Response : 0000,<data>[CR][LF] If all OK, else
NNNN[CR][LF] (NNNN = Error code)
Special Syntax 2 (Recall from RAM only):
Syntax : R<data code>,+[CR] Increments the Measurement ID (measurement number) and
recalls the data.
Response : 0000,<data>[CR][LF] If all OK, else
NNNN[CR][LF] (NNNN = Error code)
Note: If data code is not specified, code 1 will be sent. If filename.ext is not specified, data
returned will be that stored in the internal memory (RAM) of the instrument instead of
the SD card.
<data> in response code refers to the specific measurement data set returned based on the
data code sent to the instrument. Refer to the Data Code section for specific information.
S
Purpose : Assign instrument and measurement set up parameters
Syntax : S[specifier][CR]
Response : 0000[CR][LF] If all OK, else
NNNN[CR][LF] (NNNN = Error code)
X
Purpose : Set the display contrast .
Syntax : Xnnn where nnn is the contrast in % - Range 0 to 100%
Response : “Contrast set to nnn %”
See the Setup Command section for complete details
Z
Purpose : Enable Reset Command Mode
Syntax : ZEnableReset
Response : 00000,Reset Commands Enabled
Reset Commands:
ZResetPreferences – Reset all Preferences values to factory default.
ZResetSetup – Reset all Setup values to factory default.
NOTE: All Reset Commands will shut down the instrument after they are executed
.