irinox ICY L, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 36

15
Description Phase Front panel screen
4
5A
6A
3
When the cycle has been selected, the selection
screen appears: Automatic or Manual.
Click on to access the automatic cycle.
Click on to access the manual cycle.
In the event of an incorrect selection:
Press the key to go back to
the “Automatic” or “Manual” selection.
Press to go back to the initial grid.
MANUAL MODE
7A
Do not insert the Core probe into the product
Close the Blast Chiller door
Once the “manual cycle” has been selected, there is the
possibility to increase or decrease the cycle
time by pressing the “plus” and “minus” keys
.
Press and hold for over two seconds to increase
the time faster.
Press the key to start the selected cycle.
The timer cannot be set at zero as the minimum
settable time is 1 min.
8A
Once the cycle has started, the current cycle is shown
at the top to the left and the completion percentage is
shown to the right.
The display shows the time expressed in decreasing
hours and minutes from the initial cycle start, and the
probe temperature air.
9A
Use the keys shown on the
display to change the time.
Press to put the screen in stand-by while the
cycle is active.
Use the key to stop the cycle and
go back to the initial grid.