Intel® Server System M20MYP1UR System Integration and Service Guide
59
7.
Connect the removable media device to the system.
8.
Power on the system.
9.
Boot to the EFI shell.
10.
Change directories to the folder containing the update files.
11.
Update the Intel ME firmware using the following command:
iflash32 /u /ni <version#>_ME.cap
12.
When the update has successfully completed, power off the system.
13.
Remove the AC power cord.
14.
Remove the system top cover.
15.
Move the “ME FRC UPD” jumper back to pins 1
-2 (default).
16.
Re-attach the AC power cord.
17.
Power on system.
6.2.4
BMC Force Update Jumper Block
The BMC Force Update jumper is used to put the BMC in Boot Recovery mode for a low-level update. It
causes the BMC to abort its normal boot process and stay in the boot loader without executing any Linux*
code.
This jumper should only be used if the BMC firmware has gotten corrupted and requires re-installation. The
following procedure should be followed:
Note:
System Update files are included in the System Update Packages (SUP) posted to Intel’s Download
http://downloadcenter.intel.com
1.
Download the SUP and unzip the contents, copying them to the root directory of a FAT32 formatted
removable media device(USB flash drive).
2.
Turn off the system.
3.
Remove the AC power cord.
Note:
If the BMC FRC UPD jumper is moved with AC power applied to the system, the BMC will not
operate properly.
4.
Remove the system top cover.
5.
Move the “BMC FRC UPD” Jumper from pins 1
-2 (default) to pins 2-3 (Force Update position).
6.
Re-install the system top cover and re-attach the AC power cord.
7.
Connect the removable media device to the system.
8.
Power on the system.
9.
Boot to the EFI shell.
10.
Change directories to the folder containing the update files.
11.
Update the BMC firmware using the following command:
FWPIAUPD -u -bin -ni -b -o -pia -if=usb <file name.BIN
>
12.
When the update has successfully completed, power off the system.
13.
Remove the AC power cord.
14.
Remove the system top cover.
15.
Move the “BMC FRC UPD” jumper back to pins 1
-2 (default).
16.
Re-attach the AC power cord.
17.
Power on system.
18.
Boot to the EFI shell.
19.
Change directories to the folder containing the update files.
20.
Re-install the board/system SDR data by running the FRUSDR utility.
Содержание M20MYP1UR
Страница 2: ...Intel Server System M20MYP1UR System Integration and Service Guide 2 Blank page...
Страница 56: ...Intel Server System M20MYP1UR System Integration and Service Guide 56 Figure 54 DIMM fault LEDs...
Страница 103: ...Intel Server System M20MYP1UR System Integration and Service Guide 103 1 2 3 4 5 ESD 6 1 2 3...
Страница 104: ...Intel Server System M20MYP1UR System Integration and Service Guide 104 1 2 3 4 5...
