innovaphone IP DECT
Page 85
as follows:
Description
The descriptive name for the route.
Source
interface
Here, you select the ISDN or VoIP interface that is to apply as
the source for the relevant route. It is also possible to select
several sources. The source interfaces available in principle
are:
RT, RS, TEL
,
BRI
,
PRI
,
PPP
,
TEST
,
TONE
,
HTTP
,
SIP
and
GW
.
Number In
To make the routing decision dependent on a map entry, you
must enter the calling number here. If no number is specified
here, the map entry is valid for all calls.
There are additional variants of call number manipulation
available:
If a route is to apply to a particular number and all of the digits
that are subsequently dialled are to be ignored, the specified
call number must be followed by the "!" operator.
Some devices require the “#” operator as the signalling cha-
racter for the end of a call. For this, the
Add #
check box can
be checked (see description further down in the text).
With the “?” operator, it is also possible to replace a variable
unknown and known number of characters by a particular one.
For example, “???” replace with 1 gives, say for “1234” ->
“14”, or “0???” replace with 1 gives, say for “01234” -> “14”,
since the known digit 0 is likewise replaced.
With the “.” operator, a particular number of characters can be
replaced. For example, “...” replace with “123” gives, say for
“321” -> “123”.
Number
Out
Here, you enter the route’s call number to be replaced, if desi-
red. If the call number is to be adopted unchanged, the same
call number as in
Number In
must be specified here.
Note:
If the calling number was manipulated, the
Verify CGPN
check box must not be checked, since the checking of the cal-
ling number would fail, making the map entry ineffective.
Destina-
tion inter-
face
Here, you select the interface that is to apply as the destina-
tion for the relevant route. The destination interfaces available
in principle are:
RT, RS
,
TEL
,
BRI
,
PRI
,
PPP
,
TEST
,
TONE
,
HTTP
,
SIP
,
GW
,
MAP and DISC
.
Name Out
If the H.323 call name is to be changed, the new call name
can be entered here.
