page 46
innovaphone IP DECT
NI D-channel protocol:
Mode:
If your trunk line is a point-to-point type, select
Point-to-Point
. If it is a point-
to-multipoint connection, then select
Point-to-Mulitpoint
. This setting is irre-
levant for permanent connections. If the connection is operated in mixed mode
(one B channel permanently used for a fixed connection, one B channel in dial-
up mode), the setting depends on the operating mode of the dial-up line (only
TEL1-4 and PPP).
4.1.5.3 Configuration/PRI1-4 & TEL/Interop
The
Interop
submenu normally does not have to be adjusted. This is only ne-
cessary if, for example, malfunctions occur when transmitting H.323 calls.
Not all ISDN implementations are prepared to receive certain standard-compliant
information elements
(referred to as
IEs
). Such IEs can be created, for ex-
ample, when linking up different PABXs or transmitting H.323 calls to an ISDN
interface and vice-versa.
If malfunctions are caused by the transmission of certain IEs, the gateways can
be made to remove such IEs from the transmitted messages.
NI
USA (National ISDN 1)
5ESS
USA (AT&T)
DMS100
USA (new standard)
Point-to-Point
Switches on the point-to-point connection.
Point-to-Multi-
point
Switches on the point-to-multipoint connection.
Suppress Sen-
ding of HLC
No
high layer compatibility information elements
are transmitted.
Suppress Sen-
ding of FTY
No
facility information elements
are transmitted.
Suppress Sub-
address
No
subaddress information elements
are transmit-
ted.
