page 34
innovaphone IP DECT
In the
Static IP Routes
section, additional network routes can be defined, if
other network areas apart from the local network are required.
4.1.3.4 Configuration/ETH0-1/NAT
Use of NAT (
N
etwork
A
ddress
T
ranslation) for the relevant interface can be en-
abled here. It is also possible to exclude particular network addresses and masks
from the translation.
4.1.3.5 Configuration/ETH0-1/VLAN
If a network uses several VLANs (
V
irtual
L
ocal
A
rea
N
etwork), a VLAN can be
specified for every Ethernet interface
. This ensures that the data packets are
Multicast
With the Multicast setting, all data packets for sending can be
sent to all devices in a network. Data packets are sent to all
devices in a network as standard. The Multicast check box is
therefore checked.
Network
Destination
The network address of the destination route.
Network
Mask
The relevant subnet mask of the destination route.
Gateway
The standard gateway of the network being routed.
Include
Interface
in NAT
A checked check box enables NAT for the interface, providing
NAT was enabled in general under chapter “
Configuration/IP/
NAT
”. In other words, the network connected to ETH
n
is regar-
ded as external unless it was excluded under
Exclude Address
or
Exclude Mask
.
Exclude
Address
IP network that should not be included in the Network Address
Translation.
Exclude
Mask
IP network area that should not be included in the Network
Address Translation.
