Ingeteam INGECON SUN 1000TL U B360, Инструкция по установке и эксплуатации

Страница: 89 / 180

ABK2027IQE01_A - Installation and Operation Manual
After connecting the Ethernet cables, it must be led through the ducts on the unit towards the dedicated cable
entrances (see the following diagram and section
“2.19. Description of cable inlets” ).
The communication hardware allows the configuration of two Ethernet interfaces with two different IP addresses for
the same inverter.
INFO
The two network interfaces are identified as Ethernet Interface Primary and Ethernet Interface Secondary .
They are configured from the Ethernet tab in the website's main menu.
The Ethernet Interface Primary is reserved for inverter control in real time. To do this, the communication with the
plant control or PPC must be established with the IP address set in this network interface.
The Ethernet Interface Secondary is for monitoring the inverter and its internal devices. Therefore the plant Scada
or other monitoring system must establish communication with the IP address set in this network interface.
In addition, below is the configuration of the serial parameters for the Dual Ethernet card with RS-485 output.
INFO
The two serial lines are identified as Serial Interface Primary and Serial Interface Secondary .
They are configured from the Serial Interface tab in the website's main menu. After pressing the button
in the corresponding interface.
Parameters Serial Interface Primary Serial Interface Secondary
Serial Port Speed (Bauds) 115200 9600
Modbus TCP: First Char timeout 250 250
Modbus TCP: Inter Char timeout 10 50
Modbus TCP: Session timeout 240 240
Modbus TCP: Max Connections 16 16
Modbus TCP: CRC Retries 1 1
89
Connection of the communication accessories Ingeteam