SEL-1FS1/SEL-2FS1 and SEL-1XD1/SEL-2XD1
Installation and Operation Manual
Installation, Operation, and Specifications
© 2015 Imagine Communications Corp.
Proprietary and Confidential.
Version 2.8 | Page 58
On-Screen Display (OSD)
Both the FS1 and the XD1 have the capability to provide an output with or without on-screen display
(
OSD
). You can select up to ten read-only parameters to appear, using the
OSD Sel x
parameters. The
on-screen read-only values appear when
OSD Enable
is activated.
Logo 1 and 2
The FS1 and XD1 provide on-screen static logo generation capability, using logos that you store on an
SD/SDHC micro memory card. For information on the creation and storage of logo files, see Graphics
Storage and Playout Overview (on page 58).
File Select
The
Scan Files
parameter loads the next set of filenames onto the SD/SDHC micro memory card. Options
are
Next
and
Previous
. The read-only
File
x
parameters display the available logo files. Use the
Select
File
control to choose the file you need, and the
Select Raster
parameter to determine the raster size
required for the logo.
Raster x
Within the raster sizes of 1080, 720, 625, and 525, you can set the
Transparency
,
X Position
, and
Y
Position
.
Graphics Storage and Playout Overview
The MCP FS1 and XD1 store logos on an SD/SDHC micro memory card. (The card must be formatted to
FAT 32.) The following memory cards are recommended:
•
1 GB SanDisk
•
4 GB Kingston (SDC4/4GB Class 4)
•
4 GB Lexar (LSDMI4GBASBNA Class 4)
•
4 GB SanDisk (SDSDQM-004G-B35SA Class 4)
To load the graphics, you will need to use the slot located on the card-edge of the FS1 and XD1 module.
Logos used by the FS1 and XD1 must be created or saved in the .mg2 file format, and initially stored on
an SD or SDHC micro memory card at your PC workstation in the
/logos
directory. You can remove the
micro memory card at any time a logo is being displayed by the module, unless the file is being loaded.
