SEL-1FS1/SEL-2FS1 and SEL-1XD1/SEL-2XD1
Installation and Operation Manual
Installation, Operation, and Specifications
© 2015 Imagine Communications Corp.
Proprietary and Confidential.
Version 2.8 | Page 119
Enabling DTS Neural and Dolby Modes
Follow these steps to enable the DTS Neural and Dolby Modes:
1.
Select one of the four slots in the
Advanced Audio Processing (AAP)
block.
2.
Select
General > Processing Mode
.
3.
Select the processing mode you need.
4.
In the drop down box at the top of the column, change your selection from
General
to the mode
you selected in step 3.
5.
Wait several seconds for the fields to refresh.
6.
Configure the parameters that are available in your mode (parameters that are not applicable are
grayed out).
Once you have selected your DTS Neural modes, the
Selection Status
parameter
(
AAP x > General
) displays one of the following:
Good
Not Enough License Credit
Not Enough MCPS
Not Enough MCPS and License Credit
7.
From the main section of the
Advanced Audio Processing (AAP)
block, (select
AAP x Input Routing
and then select your audio sources.
8.
In the
Audio Output Routing
block, select the destinations for your audio.
See DTS Neural Products (on page 90) for more information.
Green-Power Save
You can reduce power consumption on the module by shutting down specific
AES Inputs
,
Ext Video
Inputs
and
Outputs
, or the
GPI Output.
Select
Misc > Green-Power Save
. Select
Yes
to turn
off
one of
the interfaces, or
No
to leave it on.
