SEL-1FS1/SEL-2FS1 and SEL-1XD1/SEL-2XD1
Installation and Operation Manual
Installation, Operation, and Specifications
© 2015 Imagine Communications Corp.
Proprietary and Confidential.
Version 2.8 | Page 31
Installing Selenio Modules
You can insert a Selenio module into a frame with the power supply turned on or off. Follow this
procedure:
1.
Remove a blank back module from the frame.
Do not discard the blank back modules and their captive screws. You may need them for future
configurations.
2.
Attach the new back module to the empty slot, using the mounting screws provided.
Align the back module’s pin into the guide hole, and ensure that the EMI gaskets separating the back
modules remain in place during the installation. The EMI gaskets fit tightly. To ease the installation
of back modules, gradually press each back module into place from the left side to the right side.
Figure 20:
Example of Back Module Installation
3.
Apply labels to the back module, if these are supplied separately.
4.
Print out this page and write down the placement of the back modules in the diagram below (back
modules appear on the reverse side when viewed from the front).
Figure 21:
Writing Space for Identifying Back Modules
CAUTION:
Do not mix and match back and front modules. The front module must mate with a back module of
the same product.