Imagine Panacea Lite, Руководство по эксплуатации

Страница: 39 / 205

Chapter 2
Frame Configuration and Installation
20
Copyright © 2004-2007, 2008, 2010, Harris Corporation
Control
Functionality
DIP switch mode operation allows you to operate your Panacea Lite with minimal
(and often no) additional setup. See
DIP Switch Summary on page 12 for more
information.
Power Supply
The Panacea Lite product line includes an internal power supply module. No
configuration settings are needed for the power supply. See
Power Supply on
page 6 for more information.
Installing a
Panacea Lite
Router
NOTE : Since the Panacea Lite is specifically ordered in a particular
configuration, the Panacea Lite frame will be custom configured to those
specifications.
The Panacea Lite can be installed anywhere within a routing system and can be
controlled in a variety of ways, including local or remote control panels and
PC-based software control; or serial port control with the P12×1-SP option
installed. Because the flexibility of the Panacea Lite allows for many possible
configurations, the installation procedures will depend on the desired
configuration and system design. General installation procedures are as follows:
1 Ensure that all packing foam, strapping, and tape is removed from the frame.
2 Mount the frame in an rack that provides power and cooling facilities. The
frame is designed for mounting in a standard equipment rack.
3 Align the frame so that all 4 screw holes in the mounting ears match up with
those in the rack. (Adjustable ears on each side of the frame allow adjustable
depth placement of the frame within the rack.
4 Secure the frame to the rack with the rack screws and washers.
5 Connect each source to the appropriate input connection on the back panel I/
O module.
6 Connect each destination to the output connection on the back panel I/O
module.
7 Connect the control device to the appropriate port (XY or SERIAL) on the
frame’s rear panel.
8 If the router is to be used in a multiple frame system, connect the additional
frames using the X-Y port. Be sure to terminate any unused X-Y ports. The
Panacea Lite router will not communicate properly unless at least one end of
the X-Y bus is terminated.
9 If the router is a the end of the X-Y bus, terminate the other X-Y connector
with a coaxial 75

termination.
10 Connect the power input receptacle to the power source.