Imagine Panacea Lite, Руководство по эксплуатации

Страница: 186 / 205

Panacea Lite Routing Switcher Series
Installation, Configuration, and Operation Manual
167
Copyright © 2004-2007, 2008, 2010, Harris Corporation
Installing a
P12×1-RCP
Control Panel
The P12×1-RCP control panel has the same pre-installation requirements as a
Panacea Lite routing switcher. Follow the steps outlined in the following sections to
complete the pre-installation procedures:

Ensuring Adequate Rack Space on page 18

Ensuring Proper Temperature and Ventilation on page 18

Meeting Electrical Requirements on page 19
To connect a P12×1-RCP unit to a Panacea routing switcher, you will need a
regular cable with BNC connectors at both ends.
1 Complete all pre-installation procedures.
2 Make any DIP switch configuration changes you desire (see Choosing the
Appropriate Configuration Mode on page 170 and P12×1-RCP DIP
Switch Configuration on page 172).
3 Connect one BNC connector to the X-Y port on the Panacea Lite routing
switcher back module.
4 Connect the other BNC connector to the BNC port on the P12×1-RCP.
5 Terminate any unused X-Y ports. The P12×1-RCP control panel will not
communicate properly unless at least one end of the X-Y bus is
terminated
.
6 Mount the control panel in the proper rack (the procedure is the same as the
one described in
Installing a Panacea Lite Router on page 20)
7 Connect the power input receptacles on both frame and control panel to their
power sources.
8 Between the control panel’s top and bottom function keys you will find the
key brightness adjustment (see
Figure B-6 on page 170). This adjustment
controls the light intensity of all of the control panel keys. To adjust the key
light intensity, use a small flat-head screwdriver to turn the brightness screw
clockwise (brighter) or counter-clockwise (dimmer).