IBM SAN32M1, Инструкция по установке и обслуживанию

Страница: 107 / 626

75 Chapter 2: Installation tasks
• Central processing unit (CPU) temperature.
• Hard disk capacity.
• Virtual and physical memory capacity.
10. After successful POST completion, the LCD panel displays a
Welcome!! message and all front panel LEDs extinguish.
11. If a POST error or other malfunction occurs, go to MAP 0000: Start
MAP on page 195 to isolate the problem.
12. Press the left edge (PUSH label) of the LCD panel to disengage
the panel and expose the CD-RW drive.
13. Insert a blank rewritable CD into the CD-RW drive and close the
LCD panel.
Task 7: Configure management server password and network
addresses
Verify the type of LAN installation with the customer’s network
administrator. If the management server or equipment cabinet is
installed on a dedicated LAN, network information does not require
change. Change the default password for the server’s LCD panel
(if required by the customer), then go to
Task 8: Configure management
server information on page 80.
If the management server or equipment cabinet is installed on a
public LAN segment, the default password for the server’s LCD
panel and the following transmission control protocol internet
protocol (TCP/IP) network information must be changed to conform
to the customer’s LAN addressing scheme:
• IP address.
• Subnet mask.
NOTE: At some customer installations, TCP/IP addresses for the
management server may be allocated automatically using dynamic host
configuration protocol (DHCP).