IBM Redboks System x3550 M4, Инструкция по установке и обслуживанию, Страница: 421 / 820

8007010f-2201xxxx Sensor [SensorElementName] has transitioned from normal to non-critical state. (GPT Status)
Explanation: This message is for the use case when an implementation has detected a Sensor transitioned to
non-critical from normal.
May also be shown as 8007010f2201xxxx or 0x8007010f2201xxxx
Severity: Warning
Alert Category: Warning - Other
Serviceable: Yes
CIM Information: Prefix:
PLAT and
ID:
0520
SNMP Trap ID: 60
Automatically notify Support: No
User response:
1. Check the IBM support site for service bulletins or firmware updates that apply to this GPT error.
2. Set the UEFI setting DISK GPT Recovery to Automatic.
3. Replace the corrupt disk.
8007010f-2582xxxx Sensor [SensorElementName] has transitioned from normal to non-critical state. (I/O
Resources)
Explanation: This message is for the use case when an implementation has detected a Sensor transitioned to
non-critical from normal.
May also be shown as 8007010f2582xxxx or 0x8007010f2582xxxx
Severity: Warning
Alert Category: Warning - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0520
SNMP Trap ID: 60
Automatically notify Support: No
User response: Complete the following step to solve PCI I/O resource errors:
1.
Go to F1 Setup-> System Settings-> Device and I/O ports-> PCI 64 bit Resource and choose enable.
80070114-2201xxxx Sensor [SensorElementName] has transitioned from normal to non-critical state. (TPM Phy
Pres Set)
Explanation: This message is for the use case when an implementation has detected a Sensor transitioned to
non-critical from normal.
May also be shown as 800701142201xxxx or 0x800701142201xxxx
Severity: Warning
Alert Category: Warning - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0520
SNMP Trap ID:
60
Automatically notify Support: No
User response:
1. Complete the administrative tasks that require the TPM physical presence switch to be in the ON position.
2. Restore the physical presence switch to the OFF position.
8007010f-2201xxxx • 80070114-2201xxxx
Appendix A. Integrated management module II (IMM2) error messages
403