IBM Power System LC921 9006-12P, Руководство по обслуживанию

Страница: 28 / 132

• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the
system, it is important to again discharge yourself by touching an unpainted metal surface for
at least 5 seconds before you continue with the service process.
2. Install the DOM into the system backplane, in positions (A), as shown in Figure 10 on page 14.
Depending on the DOM model, you might also have to plug in a small power cord for the DOM. Ensure
that you plug in the connectors properly.
Figure 10. Installing a DOM
3. Prepare the system for operation. For instructions, see “Preparing the 9006-12P system for operation
after you remove and replace internal parts” on page 89.
4. For a non-RAID drive, configure the installed drive for your environment. If the drive is part of a RAID
configuration, skip this step, the drive is detected and configured when inserted.
After you insert the new drive, you need to rescan for the device.
14 Power Systems: Servicing the IBM Power System LC921 (9006-12P)