IBM Power System LC921 9006-12P, Руководство по обслуживанию

Страница: 47 / 132

2. Refer to the PCIe adapter positions.
See Figure 27 on page 33.
Figure 27. 9006-12P PCIe adapter positions
Position Step
1 (UIO Slot1) “3” on page 33
A (UIO Network) “4” on page 33
2 (WIO Slot1), 3 (WIO Slot2), 4 (WIO-R Slot) “5” on page 34
3. If you are working with a PCIe adapter in position 1, complete the following steps:
a) Remove the standard tailstock from the adapter.
b) If you are inserting a storage drive adapter, connect the signal cables to the adapter before
inserting the adapter. See “Drive installation options for the 9006-12P system” on page 105 for
cabling information.
c) If needed, install a support bracket for the PCIe adapter to the system backplane. Also install a
special support tailstock to the PCIe adapter.
d) Insert the PCIe adapter into the PCIe riser.
e) If you installed the support bracket for the PCIe adapter, fasten the special support tailstock to that
bracket.
4. If you are working with the UIO Network adapter in position A, complete the following steps:
a) Replace the PCIe adapter riser into the system backplane, using points (A) and (B) as shown in
Figure 28 on page 34.
b) Replace the two screws to secure the PCIe riser card to the chassis as shown in Figure 28 on page
34.
c) If a PCIe adapter was in position 1, replace that PCIe adapter.
Removing and replacing parts in the 9006-12P system 33