IBM EXP15, Инструкция по установке и эксплуатации

Страница: 67 / 124

Working with Internal Disk Drives
Installing Hot-Swap Drives
Before you begin
Ÿ
Read “Handling Static-Sensitive Devices” on page 20.
Ÿ
Read the instructions that come with the internal drive.
Ÿ
Handle the drive-tray assembly carefully
Here are a few things to consider when installing drives:
Ÿ
Remove empty drive trays. Expansion units shipped without a
full set of drives (10) contain blank drive trays in the unused
drive bays. Before installing new drives, you must remove the
blank trays, which should be saved for future use. Each of the
ten bays must always contain either a blank tray or a tray with
a disk drive.
Ÿ
Install IBM supported SCSI drives only.
Attention: If you are replacing a drive that is part of a RAID level 1
or RAID level 5 logical drive, ensure that you install the
replacement drive in the correct bay. Failure to replace the drives in
their correct bays can result in loss of data.
Chapter 4. Installing and Replacing Devices
41