IBM EXP15, Инструкция по установке и эксплуатации

Страница: 33 / 124

Rear Controls, Indicators, and Connectors.
Power Supply Controls, Indicators, and Connectors
Power Supply CRU
Power LED
Lever
Fault LED
AC Power Connector
Power Switch
Levers: Use the locking handles to remove or install power
supplies.
Power LEDs: These green LEDs are on when the power
switches are turned on.
Fault LEDs: These amber LEDs are on after a power supply
failure or if one power supply is turned on and the other
power supply is turned off.
Power Switches: Use these switches to turn the power
supplies on and off.
Power connectors: The power cords for the power supplies
connect here.
Power Supply CRU: The two hot swap and redundant
power supplies are located here.
Chapter 1. Introduction
7