IBM eServer 250 xSeries, Руководство пользователя

Страница: 59 / 186

Chapter 5. Installing options
45
Installing a non-hot-plug PCI adapter (slots 1 and 2)
The following illustration shows how to install a non-hot-plug PCI adapter.
Note: The illustrations in this document might differ slightly from your hardware.
To install a non-hot-plug PCI adapter:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 37.
1. Review the information in“Before you begin” on page 36 through “Safety
information statements” on page 38.
2. Turn off the server; then, disconnect the power cords.
3. Remove the top cover (see “Removing the server top cover and bezel” on page
40).
4. Determine which expansion slot you will use for the adapter.
Note: PCI slots 1 and 2 support non-hot-plug PCI adapters only.
5. Remove the expansion-slot cover:
a. Rotate the adapter retention latch counterclockwise.
b. Lift the tab covering the top of the expansion-slot cover and then remove the
expansion-slot cover from the server. Store it in a safe place for future use.
c. Press on the rear adapter retention latch (near the hard disk drives) as
indicated by the arrow on the latch and lift it to the open position.
Attention: You must install expansion-slot covers on all empty slots. This
maintains the electromagnetic emissions characteristics of the system and
ensures proper cooling of system components.
Adapter retention latch Tab
Adapter
retention latch
Adapter