IBM eServer 250 xSeries, Руководство пользователя

Страница: 106 / 186

92
IBM® xSeries 250: User’s Reference
The failover function is now enabled. If a failover occurs:
• The operating system console generates a message.
• The custom counters for the device driver contain variables that define the state of
the failover function and the location of the redundant pair. You can use the
NetWare Monitor to view the custom counters.
Note: If the primary adapter was hot-replaced while the Ethernet traffic was being
handled by the secondary Ethernet controller, the traffic does not
automatically switch back to the primary adapter when the primary adapter
comes back online. In this case, issue the command:
LOAD d :\ path \PCNTNW SCAN
where d and path are the drive and path where the driver is located. This
command causes the device driver to locate the primary adapter and switch
the Ethernet traffic to it.
Ethernet port connector
The following table shows the pin-number assignments for the RJ-45 connector. These
assignments apply to both 10BASE-T and 100BASE-TX devices.
Advanced System Management ports
Your server has three communication ports dedicated to the Advanced System
Management processor. One port uses a standard D-shell serial-port connector,
connector C. The other two ports, which are used for the ASM Interconnect function,
use a dual RJ-45 connector.
You can attach a dedicated modem to the D-shell system-management connector on
the rear of your server to communicate with the integrated Advanced System
Management processor.
The ASM Interconnect function uses the RJ-45 system-management connectors. This
function enables you to connect the Advanced System Management processors of
several rack-mounted servers so that they can communicate with each other in half-
duplex mode.
Pin Signal Pin Signal
1 Transmit data+ 5 Not connected
2 Transmit data- 6 Receive data -
3 Receive data+ 7 Not connected
4 Not connected 8 Not connected
Table 14. Ethernet RJ-45 connector pin-number assignments.