IBM 88371RU, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 58 / 186

Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or external SCSI device, you might receive a message that the configuration
has changed. The Configuration/Setup Utility program starts automatically so that
you can save the new configuration settings. For more information, see the section
about configuring the server in the User’s Guide on the IBM xSeries Documentation
CD.
Some options have device drivers that you must install. See the documentation that
comes with each option for information about installing device drivers.
The server comes with at least one microprocessor. If more than one
microprocessor is installed, the server can operate as a symmetric multiprocessing
(SMP) server. You might have to upgrade the operating system to support SMP. For
more information, see the section about using the ServerGuide Setup and
Installation CD in the IBM User’s Guide and the operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see the
User’s Guide .
Installing the server in a rack
Detailed cabling instructions for a typical rack server configuration are provided on
the IBM xSeries Documentation CD that come with the server. These instructions
also come with the Tower-to-Rack Conversion Kit.
Model #
Serial #
USB connector
Figure 40. Front USB connector location
48
xSeries 336 Type 1879 and Type 8837: Hardware Maintenance Manual and Troubleshooting Guide