IBM 88371RU, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 107 / 186

Diagnostic error codes
Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
FRU. The descriptions for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace or follow the indicated FRU/action.
Note: See “System replaceable units” on page 122 to determine which components should be replaced by a field
service technician.
Error code/symptom FRU/action
001-250-000
(Failed processor board ECC)
v Microprocessor board
001-XXX-000
(Failed core tests)
v
System board
001-XXX-001
(Failed core tests)
v System board
001-292-000
(Failed processor board ECC)
v Load BIOS code defaults and rerun test.
005-XXX-000
(Failed video test)
1. Video adapter (if installed)
2. System board
011-XXX-000
(Failed COM1 serial port test)
v Check loopback plug connected to externalized serial port.
v Check cable from externalized port to system board.
011-XXX-001
(Failed COM2 serial port test)
v
Check loopback plug connected to externalized serial port.
v
Check cable from externalized port to system board.
014-XXX-000
(Failed parallel port test)
v System board
015-XXX-001
(USB interface not found, board damaged)
1. System board
015-XXX-015
(Failed USB external loopback test)
1. Make sure the parallel port is not disabled.
2. Run the USB external loopback test again.
3. System board.
015-XXX-198
(Remote Supervisor Adapter II SlimLine
installed) or (USB device connected during
USB test)
1. If Remote Supervisor Adapter II SlimLine is installed as an option,
remove it and rerun test.
Note: If Remote Supervisor Adapter II SlimLine is present as a
standard installation, do not remove it; the test cannot be run.
2. Remove USB devices and rerun test.
3. System board.
020-XXX-000
(Failed PCI interface test)
v
System board
020-XXX-001
(Failed hot-swap slot 1 PCI latch test)
1. PCI hot-swap latch assembly
2. System board
020-XXX-002
(Failed Hot-swap slot 2 PCI latch test)
1. PCI hot-swap latch assembly
2. System board
Chapter 6. Symptom-to-FRU index
97