IBM 88371RU, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 41 / 186

6. Remove the retention clip from the DVD-ROM drive or DVD-ROM blank bezel.
This retention clip will be needed when you install a DVD-ROM drive or
DVD-ROM blank bezel in the hard drive cage.
7. Go to “Installing an internal DVD-ROM drive” on page 31.
Installing an internal DVD-ROM drive
Complete the following steps to install an internal DVD-ROM drive or DVD-ROM
blank bezel:
1. Read Appendix B, “Safety information,” on page 129 and “Installation guidelines”
on page 15.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 10); then, remove the
cover (see “Removing the cover” on page 18).
Note: Make sure that you disconnect all power to the server before removing
the hard disk drives.
3. Remove the DVD-ROM drive or DVD-ROM blank bezel (see “Removing an
internal DVD-ROM drive or DVD-ROM blank bezel” on page 29).
DVD-ROM drive
DVD-ROM blank
bezel
Figure 23. Internal DVD-ROM drive and blank bezel
Chapter 3. Customer replaceable units
31