IBM 86604RU - Netfinity 5500 - 4RU, Руководство по техническому обслуживанию аппаратной части

Страница: 57 / 402

Unattended Mode Off - The user chooses the recovery
method when there is a ServeRAID
controller startup error.
On - The ServeRAID controller chooses
the recovery method when there is a
startup error.
Code Block
Version The current version level of the firmware
microcode for the ServeRAID controller.
Boot Block
Version The current version level of the microcode
loaded in the boot block for the
ServeRAID controller.
Concurrent
Commands The maximum numbers of concurrent
commands supported.
Maximum Devices
Supported The maximum number of devices
supported.
Flash Program
Count The number of times that the ServeRAID
controller microcode (Flash EEPROM)
has been
flashed or updated.
Defunct Disk
Count The current number of defunct hard disk
drives.
Rebuild Rate The setting for the rebuild rate can be
low, medium, or high priority. (The default
setting is high.)
Hot-Swap Rebuild If hot-swap rebuild is set to enable, the
ServeRAID controller will rebuild a defunct
drive automatically when all of the
following conditions exist:
Ÿ
The hot-swap rebuild parameter is
set to Enable
Ÿ
The defunct drive is part of a RAID
level 1 or RAID level 5 logical drive
Ÿ
The capacity of the replacement
drive is equal to or greater than the
capacity of the defunct drive
Ÿ
No rebuild, synchronization, or RAID
level change operation is in progress
When you replace the drive and these
requirements are met, the ServeRAID
controller automatically initiates a rebuild
of the drive without user intervention.
Offline Logical
Drive Count The current number of offline logical
drives.
Configuration
Update Count The number of times that the ServeRAID
controller configuration information has
been updated.
Netfinity 5500 - Type 8660
49