IBM 86604RU - Netfinity 5500 - 4RU, Руководство по техническому обслуживанию аппаратной части

Страница: 386 / 402

c. Place the memory board on a static-protective
surface, such as the static-protective package in
which the option came.
2. Locate the memory-module connectors on the
memory board. Determine the memory-module
connector into which you will install the memory
module.
3. Touch the static-protective package containing the
memory-module kit to any unpainted metal surface on
the server. Then, remove the memory module from
the package.
Note
To avoid breaking the retaining clips or damaging
the memory-module connectors, handle the clips
gently.
4. Install the memory module:
a. Turn the memory module (DIMM)
.13/
so that
the pins align correctly with the connector
.5/
.
b. Insert the DIMM into the connector by pressing
on one edge of the DIMM and then on the other
edge of the DIMM. Be sure to press straight into
the connector. The retaining clips
.4/
will snap
into the closed positions.
c. Make sure the retaining clips
.4/
are in the
closed position. If a gap exists between the
DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the
retaining clips and remove the DIMM; then,
reinsert the DIMM.
d. Repeat these steps for each memory module
that you install.
5. Install the memory board:
a. Hold the memory board by the top edge and
align the memory board over the memory board
connector.
b. Press on the top edge of the memory board,
insert the memory board into the connector, and
tighten the thumbscrew to secure.
6. Go to “Installing the processor housing” on page 379.
378
Netfinity Server HMM