IBM 7012 G Series, Руководство по обслуживанию

Страница: 174 / 264

Service Guide
5-4
Step 4. Setting Up the System Unit
1. Be sure the power cable on the system unit is unplugged and the power switch is set to
the Off position.
2. Remove the packing material from all of the media devices installed in the front panel.
3. Remove the rear cover and top cover.
4. Look at the memory cards, adapters, and internally installed drives to be sure they are
not loose and are in their proper positions.
5. Ensure that the cards are completely seated in the connectors by pushing down on
each card.
6. Fill out the “SCSI Device Address Record” in Appendix A of this book.
7. Ensure that the SCSI terminator is installed.
8. Install the top cover.
Step 5. Set Up Each Device Being Attached
Note: During the setup of each device, connect only the device end of the signal cable. Do
not connect the device signal cables to the system unit now.
Do the setup instructions provided in the documentation with each device being attached to
this system unit; then return to step 6 of these instructions.
Step 6. Connecting Devices to Standard I/O Ports
Using the customer planning information, or other information supplied by the customer,
connect the cables to the standard I/O ports. Start at the left connector and move to the
right to make cabling easier.
As needed, use the cable labels included in the ship group to label the cables.
Power
Parallel Port
Adapter Positions
Serial Port (S3)
Serial Port (S1/2)