IBM 6H0, Руководство по обслуживанию

Страница: 378 / 561

Table 8. Common Firmware Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
B1xx 4622 Service processor failure 1. Operator panel
Location: U0.1-L1
2. Check for system firmware
update
3. Primary I/O backplane
Location: U0.1-P1
B1xx 4633 System power control network failure 1. Check for system firmware
update
2. Primary I/O backplane
Location: U0.1-P1
B1xx 4634 SPCN loop fault 1. Check SPCN cabling
2. Go to “MAP 1540: Minimum
Configuration” on page 113.
B1xx 4644 Processor VPD fault Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
B1xx 4645 Non-processor VPD fault Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
B1xx 4646 General VPD fault Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
B1xx 4647 The machine type and model
reported by the CEC hardware do not
match the machine type and model
stored in the VPD module on the
operator panel.
Replace the operator panel, location:
U0.1–L1. Do not swap the VPD
module from the old operator panel
onto the new operator panel; leave
the new, unprogrammed VPD module
on the new operator panel. Call
service support for instructions on
reprogramming the machine type,
model, and system serial number in
the VPD module.
B1xx 4648 CEC backplane VPD failure Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
B1xx 4649 Power supply VPD failure CEC power supply
Location: U1.1-V1
B1xx 4650 A system processor failure has been
detected by the service processor. All
system processors have been reset
in an attempt to recover operations.
Information only. If the problem
persists, check the error logs for
other fault indications.
If no other fault indications are found,
go to “MAP 1540: Minimum
Configuration” on page 113.
B1xx 4651 CPU VPD fault Processor card
Location: U1.1-P1-C1
358
Service Guide