IBM 6H0, Руководство по обслуживанию

Страница: 140 / 561

Step 1540-9
Have all the cards in the list in “Step 1540-8” on page 119 been replaced with new
or original cards?
NO Go to “Step 1540-8” on page 119.
YES Go to “Step 1540-10.”
Step 1540-10
The system stopped with the
Please define system console
prompt appearing on the
system console.
Standalone diagnostics can be booted. Perform the following:
1. Follow the instructions on the screen to select the system console.
2. When the DIAGNOSTIC OPERATING INSTRUCTIONS screen is displayed, press
Enter.
3. If the terminal type has not been defined, you must use the Initial Terminal option
of the FUNCTION SELECTION menu to initialize the AIX operating system
environment before you can continue with the diagnostics. This is a separate and
different operation from selecting the console display.
4. Select Advanced Diagnostic Routines .
5. When the DIAGNOSTIC MODE SELECTION menu displays, select System
Verification .
6. Record any devices missing from the list of all adapters and devices. Continue with
this MAP. When you have fixed the problem, use this record to verify that all
devices appear when you run System Verification.
Are there any devices missing from the list of all adapters and devices?
NO Reinstall all remaining adapters, if any, and reconnect all devices. Return the
system to its original configuration. Be sure to select fast boot mode (select
enable fast boot) on the system power control menu from the service
processor main menu. Go to
″
Map 0410: Repair Checkout
″
in the Diagnostics
Information for Multiple Bus Systems
YES The boot attempts that follow will attempt to isolate any remaining I/O drawer
problems with missing devices. Ignore any codes that may appear on the
operator panel unless stated otherwise. Go to “Step 1540-11” on page 121.
120
Service Guide