IBM 6H0, Руководство по обслуживанию

Страница: 423 / 561

The eight-digit codes are as follows:
Code Action
A1FD 0000 System firmware has been corrupted and must be reflashed.
A1FD 0001 Insert update diskette 1.
A1FD 0002 Insert update diskette 2.
A1FD 0003 Insert update diskette 3.
A1FD 000n Insert update diskette n.
Notes:
1. If the wrong diskette is inserted at any time, or if the diskette is left in the drive after
it has been read,
B1FD 001F
is displayed, indicating that the wrong diskette is in the
drive.
2. If B1FD 001A is displayed at any time during the process, the service processor must
be reset by activating the pinhole reset switch on the primary drawer operator panel.
After the update process is complete, the service processor resets itself and goes
through a complete reboot.
Configuring and Deconfiguring Processors or Memory
All failures that crash the system with a machine check or check stop, even if
intermittent, are reported as a diagnostic callout for service repair. To prevent the
recurrence of intermittent problems and improve the availability of the system until a
scheduled maintenance window, processors and memory DIMMs with a failure history
are marked
″
bad
″
to prevent their being configured on subsequent boots.
A processor or memory DIMM is marked
″
bad
″
under the following circumstances:
v
A processor or memory DIMM fails built-in self-test (BIST) or power-on self-test
(POST) during boot (as determined by the service processor).
v
A processor or memory DIMM causes a machine check or check stop during run
time, and the failure can be isolated specifically to that processor or memory DIMM
(as determined by the processor run-time diagnostics in the service processor).
v
A processor or memory DIMM reaches a threshold of recovered failures that results
in a predictive callout (as determined by the processor run-time diagnostics in the
service processor).
During boot time, the service processor does not configure processors or memory
DIMMs that are marked
″
bad.
″
If a processor or memory DIMM is deconfigured, the processor or memory DIMM
remains offline for subsequent reboots until it is replaced or Repeat Gard is disabled.
The Repeat Gard function also allows users to manually deconfigure a processor or
memory DIMM, or re-enable a previously deconfigured processor or memory DIMM. For
information on configuring or deconfiguring a processor, see the Processor
Configuration/Deconfiguration Menu on page 383. For information on configuring or
Chapter 7. Using the Service Processor
403