13
Rev.
141203
i3-TRNG-CAMS-
Ax73RM
.indd
4.3 Surface Mounting
This installation method is suitable for both indoor and outdoor applications.
1. Use the Surface Mount Template to
drill 6 mm (0.2”) outer holes at the
marked template positions on the
mounting surface.
2. Insert the supplied screw anchors
into the holes on mounting surface.
3. Based on installation requirements,
use either the side or the top 3/4”
conduit hole to feed the camera
wiring through. Connect the wiring.
4. If you feeding the wiring from
the hole on the top of camera’s
back box, drill a 3/4” circular
opening in the mounting surface,
corresponding to the bottom
conduit hole of mounting template.
5. If feeding wiring from the side of
camera’s back box, no additional
openings are required on the
mounting surface.
6. Mount camera’s back box to the
surface.
7. Use the supplied Torx bit to secure
the camera module to camera’s
back box with the three silver
screws. Use the red dots on both
modules for easy alignment.
8. Adjust the lens angle by rotating
and panning the camera lens base.
Do not over-rotate the camera lens beyond the stop point to avoid damage to
the camera.
See section 4.5 for more info.
Keep the camera tilt angle at >17°.
Tip:
For the ease of setup, lift off the camera liner while adjusting the lens
position.
9. Once the desired view has been achieved, replace the camera liner until it snaps
into place.
10. Replace the camera dome housing on top of the camera module. Use the red
dots on both modules for easy alignment.
11. Use the supplied Torx bit to re-tighten 3 silver screws securing the dome bubble
housing to the camera module.
12. Remember to use sealant to maintain IP66 rating.
