12
i3-TRNG-CAMS-
73RM
.indd
Rev.
141203
4.2 Flush Mounting w/ Back Box (indoor)
This
indoor
installation method is suitable for drywall and T-bar installations only.
Do not use this mounting method for outdoor installations.
Note: It is the installer’s responsibility to ensure that the mounting surface is suitable
for installation method.
1. Use the Flush Mounting Template to cut a hole into the mounting surface.
Insert the camera inside the surface opening.
2. Remove the bottom case of the camera.
(Refer to Section 3.2)
and attach to
¾” NPT pipe (EMT or Rigid) ensuring the back box is flush with the T-bar tile.
s
s
s
achieved, replace the camera liner until it snaps back into place.
6. Replace the camera dome housing on top of the camera module. Use the red
dots on both modules for easy alignment.
7. Use the supplied Torx bit to re-tighten 3 silver screws securing the dome bubble
housing to the camera module.
3. Remove 3 shorter silver screws
(
“s” on the diagram below
),
and fasten the camera to the
back box with 3 supplied longer
screws (#7 on Accessories list on
page 5).
4. Adjust the lens angle by
rotating and panning the
camera lens base. Do not
over-rotate the camera
lens beyond the stop point
to avoid damage to the
camera. Keep the
camera tilt angle
at >17°.
See
section 4.6 for
more info.
Tip:
For the ease
of setup, lift off
the camera liner
while adjusting the
lens position.
5. Once the desired
view has been
