14
i3-TRNG-CAMS-
73RM
.indd
Rev.
141203
4.4 Surface Mounting w/ Junction box
This installation method is suitable for both indoor and outdoor applications.
1. Use the top 3/4” conduit hole to
feed the camera wiring through.
Tie in the wiring into the junction
box.
2. Secure camera’s back box to the
junction box with the supplied
screws.
3. Use the supplied Torx bit to secure
the camera module to camera’s
back box with the three silver
screws.
Use the red dots on both modules
for easy alignment.
4. Adjust the lens angle by rotating
and panning the camera lens base.
Do not over-rotate the camera lens
beyond the stop point to avoid
damage to the camera. See section
4.5 for more info.
Keep the camera tilt angle at
>17°.
Tip: For the ease of setup, lift off
the camera liner while adjusting the
lens position.
5. Once the desired view has been
achieved, replace the camera liner
until it snaps into place.
6. Replace the camera dome housing
on top of the camera module. Use
the red dots on both modules for easy alignment
7. Use the supplied Torx bit to re-tighten 3 silver screws securing the dome bubble
housing to the camera module.
8. Remember to use sealant to maintain IP66 rating.