36
i3-TRNG-CAMS-
73RM
.indd
Rev.
141203
See
Section 3.3 I/O Connectors
to locate the microSD card slot on the camera. See
Section 6.7 SD Card
for information on how to enable “Edge” motion-based video
recording.
“Edge” motion detection can also be used to trigger an E-mail being sent from the
camera. See
Section 6.8 Network Recording
for information on how to configure the
camera to send out an Email whenever “edge” motion has been detected.
6.4.1 Motion Detection Setup (“Edge”)
•
Motion Detection: Enable or Disable camera’s “edge” motion detection.
•
Sensitivity: When Enabled, set the Motion Sensitivity to HIGH, MEDIUM, LOW
•
Alarm output: To enable Ax73RM camera’s Alarm Output when motion is
detected by the camera, select “Alarm Output 1”. Then, set Digital Output to
ON in the Alarm section below. To disable Alarm Output, select “None”. See
Section 3.3 I/O Connectors
for information on how to connect an Alarm Output
to the camera.
•
Draw the motion detection area in the Preview screen. Position your mouse
cursor over the Preview window,
press and hold the left mouse
button. While holding down the left
mouse button, drag the cursor to
draw a rectangular area over the
preview screen. Release the mouse
button. The motion detection area
rectangle will be shaded purple in
the Preview window. Repeat to re-draw the motion detection area. Only one
motion detection area can be drawn per camera. Any motion detected outside
of highlighted area will be ignored by the camera. When motion is
detected inside the highlighted area, a running man icon is displayed on
the camera’s Control Panel.
