11
Rev. 161107
i3-TRNG-CAMS-Ax45RM_65RM-UM.indd
Install the Camera:
4. Insert the microSD card into the
microSD slot on the camera module
(if using).
5. Insert the camera into the cut hole
in the surface.
6. Feed all cables through the opening
in the mounting surface and
connect to the camera, including
RJ45 PoE/Network cable, AC 24V
cable (if using), alarm and audio
cables (if using). Do not apply power
until the installation is complete.
7. Use a Phillips screwdriver to turn
two black-coloured screws on
the camera module clockwise to
Locking
arms (x2)
engage the locking arms.
Tighten the arms securely
against the mounting surface.
8. Adjust the lens angle by
rotating and panning the
camera lens base. Lift off the
camera liner for easy lens
position adjustment. Do not
over-rotate the camera lens beyond
the stop point to avoid damage to
the camera.
9. Once the desired view is achieved,
replace camera liner until it snaps
back into place.
Complete the Installation:
10. Replace the camera’s dome bubble
on top of the camera module. Use
the red dots on both modules for
easy alignment.
11. Use the supplied Torx bit to re-
tighten 3 silver screws securing the
dome bubble housing to the camera
module.
