HygroMatik WL-ROL 160-1200 Series, Руководство пользователя

Страница: 54 / 76

Page 54
» Press the arrow keys to set
the time of delay
0 Sec = no delay
(see note at the end of the chapter)
» Confirm the selection with . The
program jumps back to the main
menu.
Menu item 9: "High pressure pump TS
HP
"
is not active.
11.6.10 Upstream softening system
IN
FIL
If the upstream softening system is e.g.
equipped with an automatic backwashing
device and has a potential-free switching con-
tact to show the backwashing, then the control
system can shut down the WL-ROC system for
the duration of the filter backwashing and put it
on hold.
It is also possible to connect an upstream 1-col-
umn softening system to the control so that the
RO unit goes into standby mode for the duration
of the regeneration.
» Press the arrow keys to
select if relay input should be active
or inactive.
» Confirm the selection with . The
program jumps to submenu "10B".
»
» Press the arrow keys to set
the switching direction.
N.O. CONTACT = The input functions as a
normally open contact.
N.C. CONTACT = The input works as a nor-
mally closed contact
» Confirm the selection with . The
program jumps to submenu "10C".
» Press the arrow keys to set
the time of delay.
0 Sec = no delay
(see note at the end of the chapter)
» Confirm the selection with . The
program jumps back to the main
menu
8C INPUT DELAY
00Sec
9 PUMP TEMP IN
10 SOFTENER
10 SOFTENER
11 SPUELUNG
10A SOFTENER
ENABLED
10B SOFTENER
CONTACT N.O.
10C INPUT DELAY
00Sec