HygroMatik WL-ROL 160-1200 Series, Руководство пользователя

Страница: 50 / 76

Page 50
Enter a delay time by pressing the
arrow keys. The delay is intended to prevent
the system from being switched off abruptly
due to temporary measurement value peaks.
0 Sec = no delay
(see note at the end of the chapter)
» Confirm the selection with
.
The
program jumps to the submenu 4D".
Press the arrow keys to select
whether the set point function (monitoring of
the conductivity limit value during production)
should be active or inactive.
YES= active
NO = inactive
Confirm the selection with . The program
jumps back to the main menu.
11.6.6 Lower level switch LS
LOW
With the aid of the level switch, the minimum
fill level in the permeate vessel can be moni-
tored and the system can be started automat-
ically if the pressure falls below the required
level.
» Select 5 LOW LEVEL
» Press the arrow keys to
select if pressure switch should be
active or inactive.
ENABLED= active
DISABLED = inactive
(not recommended)
» Confirm the selection with
If the set point function has been activated,
the program jumps to submenu "5B".
Press the arrow keys to set the
switching direction.
N.O. CONTACT = The input functions as a
normally open contact.
N.C. CONTACT = The input works as a nor-
mally closed contact
» Confirm the selection with . The
program jumps to submenu "5C".
4C DELAY
ENABLED
4D INSTR. ON HOLD
YES
5 LOW LEVEL
6 HIGH LEVEL
5A LOW LEVEL
ENABLED
5B LOW LEVEL
CONTACT N.O.
5C INPUT DELAY
00Sec