Hydronix Hydro-Control VI, Руководство по установке

Страница: 77 / 104

Chapter 6 RS232 Interface
Hydro-Control VI Installation Guide HD0455 Rev 1.9.0 77
51 Cement In Error
52 Water Meter Fault
53 Leaking Water Valve
54 No Water Required
55 Too Much Water Calculated
56 Pre-wet Target Not Reached
57 Mix Too Wet Rejected
58 Mix Too Dry Rejected
59 Mix Too Wet Accepted
60 Mix Too Dry Accepted
61 Water Limit Exceeded
62 Max Dry Mix Time Reached
63 Max Wet Mix Time Reached
64 Mix Aborted
65 Sensor Fault
66 Mixer Blades Worn
3.3
Reading and writing recipe parameters
The recipe values of each recipe can be set at any time except if the recipe is currently in use.
If the recipe is currently in use then commands to change parameters will be applied to the next
mix started.
To read parameters the following format should be used:
• #_R_nn_pp
“_” denotes a space
, do not use the underscore character in the RS232 string, “nn” denotes
the recipe number and “pp” denotes the parameter to read.
To write a recipe parameter the following format should be used:
• #_W_nn_pp_vv
“_” denotes a space
, do not use the underscore character in the RS232 string, “nn” denotes
the recipe number, “pp” denotes the parameter to change and “vv” is the value to set it to.