Hydronix Hydro-Control VI, Руководство по установке

Страница: 69 / 104

Hydro-Control VI Installation Guide HD0455 Rev 1.9.0 69
Chapter 6 RS232 Interface
1 Port Settings
1.1
RS232
The RS232 port settings should be set up as follows
• Baud Rate – 9600
• Data Bits – 8
• Parity – None
• Stop Bits – 1
• Handshaking – None
1.2
Ethernet
The Ethernet port can also be configured to utilise the RS232 protocol. The required IP address is
displayed in the Remote Communications section and the connected device should be set to
communicate on port 23. If connecting to a Hydro-Control outside the local network please consult
the network administrator to configure port forwarding.
2 RS232 Protocol Configuration
The RS232 Protocol parameter sets whether the serial communications protocol used on the
Hydro-Control is set to the Hydro-Control VI mode or the older Hydro-Control V or Hydro-Control
IV modes. If the Hydro-Control VI is replacing a Hydro-Control V or Hydro-Control IV and the
remote communications are in use then this should be set to HC05 or HC04 respectively. HC06
v1 can be selected for systems designed using the HC06 v1 mix log format. HC06 v2 can be used
for systems designed using the HC06 v2 mix log format.
Figure 48 - RS232 Remote Comms screen
Using this screen it is possible to view RS232 commands received by the unit and replies sent
from the unit. If a large amount of data is sent out such as the entire mix log for instance it can
take some time to update this screen with all the data sent.