HydraMaster CTS 330, Руководство пользователя

Страница: 95 / 151

HydraMaster Corporation
Page 10-2 : CTS 330 Owner’s Manual
CTS 330
Hot Carbonating Truckmount System
2.0. Turns over but will not start. There is no spark
Note: To check for spark, use the following procedure. Remove a spark plug from
the engine. Attach the lead wire back onto the plug. Ground the threaded part of
the spark plug to an unpainted engine surface. While holding the plug and wire
assembly by the insulated wire, crank the engine over by turning the ignition switch
to the “start” position. You should observe a blue spark between the two elec-
trodes of the spark plug.
2.1. Recovery tank is full. Empty the tank.
2.2. Recovery tank float is defective . Disconnect float. If engine starts, replace the
float.
2.3. Note: It is important to use only Briggs oil filters. Even though an after-market filter
may fit, the internal by-pass system may not be compatible with the Briggs engine
resulting in low oil pressure.
2.4. The high temperature switch has shut the engine down . Observe the tem-
perature gauge. If it is above the normal operating range, allow the machine to
cool down. If it will still not start, disconnect the high temp switch. If the machine
then starts, replace the switch.
2.4.1. If the machine starts after it has cooled down, refer to the Heating System section,
1.0.
2.5. The spark plugs are faulty . Remove and inspect. Replace as necessary.
2.6. The engine ignition system is malfunctioning . Refer to a qualified engine ser-
vice technician for inspection.
3.0. Turns over but will not start. There is spark.
3.1 . Fuel is not reaching the carburetor inlet . Check the fuel pump. If the pump is
working, inspect the fuel lines between the fuel source and the carburetor. Repair
or replace any faulty parts as necessary.
3.1.1. If the pump is not working, check for 12 volts and a ground at the pump.
3.1.2. If 12 volts is not present at the pump, check the wiring to the pump, including the
fuse. Repair or replace as necessary. Note: If the fuse has blown, carefully
inspect the wiring for a shorted or damaged wire. Repair immediately.