HydraMaster CTS 330, Руководство пользователя, Страница: 37 / 151

Page 4-7 : CTS 330 Owner’s Manual
Hot Carbonating Truckmount System
CTS 330
3. Clean the filters and orifices with fresh water or compressed air. Perform this operation
daily
(
Figure 4-13
) .
4. Re-install filters and orifices (
Figure 4-14
).
Blower Heat Exchanger
The Blower Heat Exchanger should be inspected on an annual basis or anytime there are
indications that it might be clogged. Symptoms could include reduced vacuum, reduced
engine power, increased back pressure or overheating.
Inspect fins for debris, hair, carpet fibers, dirt, carbon buildup on the exhaust side. If
required, have the heat exchanger core cleaned or professionally descaled.
General Maintenance
1. Inspect hoses.
2. Inspect wire connections.
3. Check nuts, belts, and hose clamps.
Freeze Guard Information
Your machine should be protected from freezing for any temperature below 35° F.
Freeze Guard Procedure
1. Empty solution tank. Once they have been emptied reinstall the lid and all the
hoses.
2. Turn the Solution Valve to the “Purge” position.
3. Turn the Air Valve to the “Cleaning Mode” position.
4. Run the machine for approximately 3 to 5 minutes.
5. Empty the recovery tank.
Figure 4-14
Figure 4-13
CAUTION
!
CAUTION
!
Water freezes at 32° F
Excessive exhaust back pressure can result in premature component failure.