HydraMaster CTS 330, Руководство пользователя, Страница: 29 / 151

HydraMaster Corporation
Page 3-2 : CTS 330 Owner’s Manual
CTS 330
Hot Carbonating Truckmount System
Flood Extraction
1. Position Solution Valve to PRIME mode ( Figure 3-2 ).
2. Position Compressor Valve to PRESSURE RELIEF
(
Figure 3-2 ).
3. Set Cleaning Mode switch to EXTRACT ON mode.
4. Connect vacuum hoses and tool.
5. If equipped, switch Auto Pump Out to ON.
6. Disconnect out-going quick connects on chemical
tanks.
Notes:
The Compressor Valve must be positioned in the PRESSURE RELIEF during flood
extraction. If the valve is left in the CLEANING MODE, this may cause damage to
the air compressor and related components.
The Solution Valve must be positioned in the PRIME mode during flood extraction. If
the valve is left in the CLEANING MODE, the system may build up excessive pres
sure, which could cause damage to the machine.
Solution Fill Procedure
1. Position Compressor Valve to PRESSURE RELIEF.
2. Remove the lids from the solution tanks.
3. Disconnect hoses if necessary (
Figure 3-3 ).
4. Fill solution tank with solution.
5. Replace the lids on the chemical tanks.
6. Reconnect hoses if necessary.
7. Position the Compressor Valve to CLEANING MODE.
Notes:
Solution tank recharge time will vary depending on the level of the solution.
Figure 3-2
Figure 3-3