HydraMaster CTS 330, Руководство пользователя, Страница: 81 / 151

Page 6-1 : CTS 330 Owner’s Manual
Hot Carbonating Truckmount System
CTS 330
Compressor System
The compressor pump in this machine is also referred to as an oil-less reciprocating piston
pump. The performance and life of this unit is greatly dependent on the care and proper
maintenance it receives.
The compressor is belt and clutch driven. The clutch is controlled by the pressure switch
located on the front panel. The compressor operates as follows:
„
With the cleaning mode switch in “Cleaning Mode” and the pressure in the solution
tank is below the set point, the pressure switch will activate the clutch. This allows
the compressor to turn and pressurize the system.
„
With the cleaning mode switch in “Cleaning Mode” and the pressure in the solution
tank is above the set point, the pressure switch will deactivate the clutch. This will
turn off the compressor.
„
With the cleaning mode switch in “Extraction Mode” the clutch will turn off regardless
of the pressure in the solution tank.
The compressor should be well ventilated. Objects place or installed adjacent to the pump
will significantly reduce the life of the pump
Filtration: Periodically check the inlet air filter. To clean filter, disassemble filter housing and
use compressed air to blow dirt particles from the filter element. Replace filter when
element can no longer be cleaned with this method
Do not operate without an inlet air filter. Excessive dirt, foreign particles, moisture, or
liquids entering the pump can contribute to poor performance and/or premature failure.
Dirty filters reduce pump performance by restricting air flow.
Lubrication: The CTS 330 compressor is a dry, oil-less compressor. The product uses
sealed grease packed bearings and does not require additional lubrication
DO NOT LUBRICATE. Adding grease products to this unit will reduce performance and
can potentially damage the product.
CAUTION
!
CAUTION
!
CAUTION
!