HydraMaster CTS 330, Руководство пользователя

Страница: 32 / 151

HydraMaster Corporation
Page 4-2 : CTS 330 Owner’s Manual
CTS 330
Hot Carbonating Truckmount System
Engine Oil and Filter Change
Tools:

11/16 inch wrench

5/8 inch wrench

Oil filter wrench
1. Remove oil drain cap from drain hose located on the right side of the engine (
Figure
4-2
). Do not reinstall cap until you begin filling the engine with oil (refer to step 4)
2. Remove oil filter located on the left side of the engine (
Figure 4-3
).
3. Apply oil to the new oil filter gasket. Install oil filter (HRI part # 049-014).
4. Remove the oil fill cap located on top of the valve cover.
5. Begin filling engine with 30W. After the oil begins to flow out of the oil drain fitting,
re- install the cap. This will allow air to evacuate from the system and give accurate
oil level readings. Engine oil capacity is approximately
1.75
quarts with filter.
Failure to do this step will result in an insufficient amount of oil in the engine!
6. Check oil dipstick for proper level.
7. Re-install the oil fill cap.
WARNING
!
Figure 4-2
Figure 4-3