HydraMaster CTS 330, Руководство пользователя, Страница: 28 / 151

Page 3-1 : CTS 330 Owner’s Manual
Hot Carbonating Truckmount System
CTS 330
Operating Instructions
Do not jump start machine! Damage may occur to Electrical System!
Start Up
1. Perform daily and periodic maintenance as specified in
this Owner’s Manual.
2. Pull out choke knob (located behind the dash).
3. Move throttle lever to IDLE position.
4. Start engine.
5. Push in Choke knob.
6. Allow engine to warm up in the idle position for 3-5
minutes.
7. Move throttle lever to HIGH position (
Figure 3-1 ).
Note: For optimal solution temperature, block off vacuum port
for 5 minutes prior to cleaning.
The machine cannot be run in the IDLE position for cleaning upholstery, carpet or
flood extraction. This will void the warranty.
Carpet or Upholstery Cleaning
1. Fill solution tank with solution.
2. Position the Compressor Valve to CLEANING MODE.
3. Position the Solution Valve to CLEANING MODE.
4. Change Cleaning Mode switch to CARPET MODE.
This will engage the compressor clutch and put the temperature control on auto.
5. Connect the solution and vacuum hoses to the tool.
6. Commence cleaning.
Notes:
The machine operates at a pressure of 100 - 120 psi.
If the Solution Valve is left in the PRIME position, the solution will evacuate from the
chemical tanks into the recovery tank.
If the solution tanks run dry, air will fill the system. After the solution tanks have been
filled, with solution, purging the air from the system may require several minutes.
This can be expedited by turning the solution valve to prime for 15 seconds, then
returning the valve to cleaning mode.
Figure 3-1
WARNING
!
WARNING
!