HydraMaster CTS 330, Руководство пользователя, Страница: 94 / 151

Page 10-1 : CTS 330 Owner’s Manual
Hot Carbonating Truckmount System
CTS 330
Engine Troubleshooting
1.0. Will not turn over
1.1. There is a loose or corroded battery terminal . Clean and tighten the battery
terminal connections.
1.2. The battery is dead . Recharge or replace the battery. Test the charging system.
Repair if necessary.
Do not attempt to jump-start this machine from a running vehicle. The amperage output
from an automobile will damage the charging system of the truckmount.
1.3. The 30 amp main power fuse in the electrical panel has blown . Inspect the
wiring thoroughly to locate shorted or damaged wires.
1.4. The vacuum blower has seized . Attempt to turn the engine by hand. If it will not
turn, refer to Vacuum Troubleshooting in Section 6-3.
1.5. The ignition switch is defective . Test to see if there is 12 volts to the switch. If
there is, but there is not 12 volts going from the switch, replace the switch.
1.6. There is a problem with the starter solenoid . If there is 12 volts at the battery
connection and at the key switch connection with the key in the start position but
there is not 12 volts on the starter connection of the solenoid, replace the solenoid.
1.7. The starter motor is defective . Check to see if the engine can be turned over by
hand. If it can and if there is 12 volts from the starter solenoid to the starter, replace
the starter.
1.8. There is a mechanical problem with the engine . If the engine can be turned
over by hand and the vacuum blower is not locked, refer the engine to a qualified
service technician to determine the cause of the problem.
WARNING
!