HydraMaster CTS 330, Руководство пользователя

Страница: 124 / 151

27
9. Remove cover.
10. Loosen the set
screws on the oil
slingers [Items 45 &
46] and remove the
oil slingers from the
rotor shafts. (Refer
to Figure 12)
11. Remove ten (10)
cap screws [15] that
secure drive end
plate [3] to housing
[1].
12. Use a jaw puller to
remove drive end
plate. (Refer to
Figure 14)
13. Press rotors out of
end plate in press
if available. If press
is not available,
support end plate
and rotors in the
housing. Block up
housing and use a
soft mallet to drive
the rotors out. (Refer
to Figure 15)
14. A jaw type puller can
also be used. (Refer
to Figure 13)
15. Using a tube or
round bar of a
slightly smaller
diameter than the
shaft clearance
holes in the end
plates, tap the
bearings out of the
end plates. Bearing
retainers [22] must
be removed before
knocking out the
bearings. (Refer to
Figure 16)
16. Remove seals from
both end plates
with a punch or dull
chisel. The seals will
be damaged during
removal and must be
replaced.Inspect all
parts for wear and or
damage.
17. Clean and inspect all
parts for burrs and
polish seal journals with at least 320 grit emery or crocus
cloth.
Figure 10 - Pulling Driven Gear
with Jaw Puller
Figure 11 - Pulling Drive Gear
with Bar Puller
Figure 12 - Pulling Drive End Plate
Figure 13 - Driving Rotors
Out Using Jaw Puller
Figure 14 - Pulling Drive End Plate
Figure 15 - Driving Rotors
Out Using Soft Mallet
Figure 16 - Tapping Bearings
Out of End Plates